Select your country
Prices Inc.Tax Excl.Tax

Air curtains

Air curtains

The air curtains are HVAC devices that separate the indoor and outdoor environment by means of an optically non-interfering air stream. The air curtains are installed to save on heating costs of buildings where doors are frequently or constantly open. The air curtains create a thick air barrier and thus prevent the exchange of warm indoor air and cold air from outside, thus helping to reduce the energy consumption costs of heated areas. The air curtains are available without or with heating (water or electric).

COR N

COR N

The COR air curtains are used to reduce cold air penetration and reduce warm air leakage from buildings. The efficiency of the system increases or decreases depending on the type of curtains used and to the overall installation conditions in the building. The general effect of the air curtains is to reduce the heat losses due to the open door. The COR series curtains are designed for permanent installation above entrances and doors up to a height of 3 m, the minimum placement height is 1,8 m. The efficiency of the curtain depends on the pressure conditions in the door.

The air curtains are available with or without heating and are installed above the doors. The curtain must cover the entire width of the opening. The air is drawn in from the front of the air curtain and is exhaled downwards in order to shield the door opening and minimize heat losses. If it is necessary to cover a door opening with larger width, it is possible to use several curtains next to each other. Subatmospheric pressure in the building significantly reduces the efficiency of the air curtain, so it is necessary to ensure balanced ventilation! The air flow velocity and heating are regulated, depending on the type, in two or three stages on the controller.

 

PA

PA
 

ADA

ADA

The ADA air curtains are suitable for use in cold storage warehouses and generally in premises where cold air needs to be maintained. The advantage is the possibility to apply their resistance from -20 °C. The air curtains create an air barrier that prevents warm air from entering the refrigerated space. This leads to energy savings and thus saving on cooling costs. The ADA air curtains can be used to shield even wider entrances. For this purpose, the air curtains can be installed next to each other. The air curtains have suction in the front so they can be installed where there is less space above the entrance. The air curtains are standardly available with a 1,8 m power cable with plug, wall bracket, adjustable grille and built-in two-stage speed controller. The maximum recommended installation height is 2,5 m.

 

Portier

Portier

The Portier PS air curtains have an elegant appearance and matt stainless steel front panels and are therefore are installed in interiors with architectural demands. The Portier PS design air curtains are suitable for installation above entrances in shopping centres, banks, hotels, restaurants, etc. where there is large traffic of people or a continually open entrance is considered.

When installed above a wide door entry, several curtains can be installed next to each other using a connecting piece. The stainless steel air curtains are equipped with an adjustable grille, automatic temperature control, two levels of regulation, three speed levels and two levels of heating power. Recommended installation height is 2,5 m.

 

Corinte

Corinte

The Corinte stainless steel air curtains are designed for generally architecturally demanding buildings where the design is essential, such as banks, hotels, restaurants, etc. The curtains can be installed horizontally above the door or vertically next to the door depending on the space available. The Corinte air curtains have an integrated motherboard for the intelligent SIRe control system. The SIRe control system is further divided into three control sets - Basic, Competent, Advanced. Thanks to the SIRe control, the curtains can become a completely automatic system, which itself will maintain the temperature according to the ambient temperature, the frequency of door opening or time adjustment, etc. Recommended installation height is 3 m.

 

COR FT

COR FT

The COR-FT / COR-FTW air curtains are used to reduce the penetration of cold air and the leakage of warm air from buildings. The COR FT and COR FTW are specially designed for installation in false ceilings. The overall effect of the air curtains is to reduce heat loss, which occurs due to open doors. The curtains are supplied with electric heating, without heating or with water heating - type FTW.

 

AGS

AGS

The AGS industrial air curtains are suitable for high door openings in industrial buildings, shopping centers, etc. The recommended installation height is 5.5 m. The air curtains are designed for installation in suspended ceilings or for visible installation directly above the entrance area. When installed above a wide door entry, several curtains can be installed next to each other. The AGS air curtains have an integrated motherboard for the SIRe intelligent control system. The SIRe control system is further divided into three control sets - Basic, Competent, Advanced. Thanks to the SIRe regulation, the AGS air curtains can become a fully automatic system that will maintain the temperature depending on the ambient temperature, the frequency of door opening or time adjustment, etc.

 

AGR

AGR

The AGR industrial air curtains are suitable for high door openings in industrial buildings, shopping centres, etc. Recommended installation height is 5,5 m. The AGR air curtains are designed for installation in suspended ceiling or for visible installation directly above the entrance area. When installed above a wide door entry, several curtains can be installed next to each other.

The AGR air curtains have an integrated control motherboard of the intelligent SIRe control system. The SIRe control system is further divided into three control sets - Basic, Competent, Advanced. Thanks to the SIRe regulation, the AGR curtains can become a fully automatic system that will maintain its own temperature depending on the ambient temperature, the frequency of door opening or time adjustment, etc.

 

AR

AR

The AR air curtains are designed for concealed installation in suspended ceilings. The curtains have a low construction height, so they are installed where there is little space above the entrance door. The AR curtains are equipped with a built-in regulation and a remote control or have an integrated control board of the intelligent SIRe control system. Thanks to the SIRe regulation, the air curtains can become a fully automatic system, which itself will maintain the temperature depending on the ambient temperature, the frequency of door opening or time adjustment, etc.

 

DOR

DOR
 

Doormaster C

Doormaster C

The Doormaster C are air curtains designed for buildings with a door height of up to 2.5 m. The C1 air curtains consist of a self-supporting skeleton and cover panels made of galvanized sheet metal. The side covers are plastic. The colour of the curtain surface is RAL 9002. On request, the curtains can be equipped with fan power controllers. 

 

Doormaster D

Doormaster D

The Doormaster D are door air curtains intended for buildings with a door height of 2,4 - 3,0 m. The door air curtains D2 consist of a self-supporting frame with cover panels made of galvanized sheet metal. The side panels are plastic. The outlet chamber is supplied with thermal insulation. The colour of the curtain surface is the RAL 9002 tone. They are equipped with three-stage regulation motors.

 

Doormaster P

Doormaster P

The Doormaster P industrial air curtains are designed for installation indoors, next to or above the entrance area. The air curtains can be used mainly in production, industrial or warehouse halls, repair shops, car washes, etc. The Doormaster P air curtains are available in several type series according to output, in versions without heating, with water or electric heating. The industrial air curtains consist of a radial fan, for heating air curtains with electric or water heater, inlet grilles and outlet slits. The air curtains can be supplemented with an EU3 filter. The curtains are made of galvanized sheet steel and can be available in RAL 9002 or in other colours on request.

 

AGI

AGI
 

UF

UF

The UF industrial air curtains are designed for industrial buildings where a wide space needs to be shielded. The UF curtains are installed vertically, indoors or outdoors on the sides of the entrance areas. If the entrance area is too wide, two curtains can be installed facing each other. The air curtains have integrated silencers for suction and discharge. The air inlet for floor installation is also included. The curtains are made of galvanized steel sheet with noise insulation of mineral wool.

 

RDS / SFS

RDS / SFS

The air curtains are specially designed for revolving doors. The curtains prevent cold air from entering the interior of the building. The SFS curtains are designed for vertical mounting next to revolving doors. The RDS curtains are always made to order, these curtains are designed to be mounted above revolving doors. The air curtains can be easily controlled thanks to the integrated mother board of the intelligent SIRe control system. The SIRe control system is further divided into three control sets - Basic, Competent, Advanced. Thanks to the SIRe control, the curtains can become a completely automatic system that will maintain its temperature according to the ambient temperature, according to the frequency of door opening or according to the time setting, etc.

 

AXI

AXI

The AXI door air curtains are intended for industrials buildings. The AXI air curtains are installed in vertical (V) or horizontal (H) position. The air output can be controlled using 0-3 degree speed controllers or ∆ / Y switches. The AXI door curtains are standardly supplied without heating, with water heating or with electric heating.

Upon request, it is possible to supply the door air curtains with a high temperature 120 °C and high pressure steam heat exchanger and it is also possible to supply two-row and four-row exchangers.

The air curtains AXI are standardly made of galvanized steel sheet in the RAL 7035 colour and it is possible to deliver them with a varnishing according to the RAL sampler on request. The construction of the air curtain allows an installation of directional exhaust plates for an optimum function of the air curtain.

 

AIR DOOR AD

AIR DOOR AD

The AD air curtains without heating are suitable for placement above entrances of shopping centres, office or industrial buildings, etc. The AD air curtains are designed for installation at heights of 2.3 - 4 m and are equipped with two-speed tangential motors which ensure quiet operation. An infrared remote control with two speed settings and a damper to change the airflow are included in the delivery.

 

Viento

Viento

The Viento air curtains are suitable for installation at entrances in warehouses, exhibition and service areas, department stores, shops, banks, etc., where their sound insulation guarantees quiet operation, and convince with their high efficiency and economy. The Viento air curtains create an air barrier separating the interior from the influence of the outside environment, effectively preventing energy losses caused by uncontrolled air exchange.

The Viento air curtains are available without heating or with water heater for a maximum inlet temperature of +110 °C and can be installed at door heights of 2.5 - 3.5 metres. Speed control is possible with the built-in 5-stage autotransformer in use with external controllers.

 

Guard

Guard

The Guard air curtains are a modern and design solution for shielding the entrances to commercial buildings such as shopping centres, hotels, restaurants, schools, etc. The Guard air curtains are supplied with water and electric heating or without heating and are suitable for mounting at a height of 4 meters. The electrically heated curtains use a new type of PTC heater, which is significantly more efficient and energy saving. The Guard air curtains are automatically equipped with a three-speed motor and mounting brackets. The mounting possible in vertical and horizontal position.

 

Guard Pro

Guard Pro

The Guard Pro industrial air curtains are a modern and design solution for shielding entrances to industrial buildings such as car repair shops, production halls, access ramps, warehouses, etc. The Guard Pro industrial curtains are supplied with water and electric heating or without heating and are suitable for mounting at a height of 7.5 meters. The electrically heated curtains use a new type of PTC heater, which is significantly more efficient and energy saving. The Guard Pro air curtains can be mounted in vertical or horizontal position.

 

Wing

Wing

The WING air curtains are designed for entrances and doorways with a maximum installation height of up to 4 m. The curtains create an air barrier that prevents cold air from entering the interior space and thus maintain a comfortable climate inside. Thanks to their minimalist shape, the comfortable WING air curtains are suitable for demanding interiors of shops, cinemas, offices or warehouses and production halls and are available in RAL 9016 white or RAL 7016 grey.

The WING air curtains are available in three sizes (1, 1.5 and 2 metres) and in versions without heating or with water or electric heating. The air curtains with electric heating have a heating capacity of 2-15 kW, the air curtains with water heating of 4-47 kW. The WING air curtains can be installed horizontally or vertically (only versions without heating or with water heating), protection IP 20.

 

Wing Pro

Wing Pro

The Wing Pro industrial air curtains are designed for industrial buildings and can be installed in vertical or horizontal position. The Wing Pro air curtains are available with water heating equipped with a single or double row heat exchanger (range up to 7.5 m) or without heating (range up to 8 m) in two sizes 1.5 and 2 m. The air output can be controlled by a speed controller in three stages. Maximum heating medium parameters are 130°C, 1.6 MPa. The Wing Pro air curtains are made of galvanized sheet metal without painting and are equipped with EC motors, IP 54.

 
novy