REE 050TR0

REE TR0 is manual electronic controller of speed the fan (installation on the plaster in box with IP54) designed for sigle-phase fans with engine 230V/50Hz. The controller is equipped with built-in relay of thermal protection, which interrupts the power supply of fan in case of thermal contact TK engine winding. Mains power supply fan can be switched on again by flipping a switch located on the side of the controller to "0" then "1" after sufficient cooling of the engine.
Input terminals on the thermostat FT interrupts the power supply fan at open circuit. On delivery controller terminals are connected FT standard. Resuming after disconnection of the controller terminals FT is the same as for open circuit with thermal contacts TK. Controller REE TR0 is equipped with output terminal 230V for operating dampers, el. heaters or other external device. When operating the fan to the output terminals is always 230V. In position 0 or open circuit at the terminals FT and TK are output terminals phase fan without tension.
The controller is equipped with output terminals 230V/2A fault. LEDs on the front indicate operation or fan failure. A protective housing is made of plastic. Supply voltage is 230V, 50/60Hz. The controller can be connected in parallel multiple motors, the sum of the currents must not exceed the max. Load current regulator. Maximum load current up to 5A and 10A.